Table 10 System Settings: Server - ZyXEL Communications VSG-1200 User Manual

VSG-1200 User's Guide

Table 10 System Settings: Server

LABEL
Web Server
Administrator Idle-Timeout Specify how many minutes (between 1 and 1440) the web configuration
DHCP Server
Disable
DHCP Relay
DHCP Server IP Address If you select DHCP Relay, enter the IP address of the real DHCP server.
DHCP Server
DHCP Pool Start IP Address Enter the first of the continuous addresses in the IP address pool. The
Primary/Secondary DNS IP
E-mail Server Redirect
IP Address or Domain Name Specify the IP address or the domain name of the e-mail server to which
60
DESCRIPTION
Server Port Specify the port number of the embedded web server on the VSG for
accessing the web configurator. The default port number is 80.
Enter a number between 8010 and 8060 to access the web configurator
behind a NAT-enabled network. If you enter a number between 8010
and 8060, you need to append the port number to the WAN or LAN port
IP address to access the web configurator. For example, if you enter
"8010" as the web server port number, then you must enter "http://
www.192.168.1.1:8010" where 192.168.1.1 is the WAN or LAN port IP
address.
SSL Security Secure Socket Layer (SSL) security allows you to create a
secure connection between the VSG and the client computer(s). Refer to
Chapter 22, "Secure Socket Layer," on page 173
Select this option to activate SSL security. By default, SSL login security
is disabled.
can be left idle before the session times out. After it times out you have
to log in with your username and password again. Very long idle
timeouts may have security risks.
Note: This does NOT apply to the SMT management
session.
Select the DHCP mode on the LAN.
Select this option to disable DHCP server on the LAN.
Select this option to set the VSG to forward network configuration
requests to a DHCP server on the LAN network. Then configure the
DHCP Server IP Address field.
Select this option to set the VSG to assign network information (IP
address, DNS information etc.) to Ethernet device(s) connected to the
LAN port(s). This is the default setting.
default is 10.59.1.2 (based on the default LAN IP address of 10.59.1.1).
DHCP Pool Size This field specifies the size or count of the IP address pool. Enter a
number not greater than 1024. The default is 253.
Lease Time Specify the time (in minutes between 1 and 71582788) a DHCP client is
allowed to use an assigned IP address. When the lease time expires, the
DHCP client is given a new, unused IP address.
Enter the IP address of the DNS server(s) in the Primary DNS IP
Address Address and/or Secondary DNS IP Address fields.
Note: You must specify a DNS server.
You can set the VSG to redirect and send subscriber's E-mail via a
specified e-mail server. This feature allows subscribers to send E-mail
via the local E-mail server when their default e-mail server is not working
or prevented by relay restrictions.
the VSG forwards e-mail.
for more information.
Chapter 4 LAN, WAN and Server Setup