VSG-1200 User's Guide
24.2.3 PPTP Support
To activate PPTP support on the VSG, enter T in the WAN Type field to display the WAN
Configuration screen as shown next. Refer to the related web configurator section for
background information.
Figure 138 SMT: WAN Configuration: PPTP
WAN Type? (D/S/P/T)
Local IP Address
Local Subnet Mask
Gateway IP Address
Server IP Address
Username
Password
Connect Setting? (C/K)
Max idle Time(Min)
Optional Setting
Connection ID/Name
PPP MTU Setting
TCP MSS setting
The following table describes the PPTP-related fields in this menu.
Table 66 SMT: WAN Configuration: PPTP
FIELD
WAN Type? (D/S/
P/T)
Local IP Address
Local Subnet
Mask
Gateway IP
Address
Server IP Address Enter the IP address of the PPTP server.
Username
Password
Connect Setting?
(C/K)
Redial Period
(Sec)
194
WAN Configuration
:T
:
:
:
:
:
:
:C
:10
:
:1460
:1400
DESCRIPTION
Enter T to enable PPTP support.
Enter the (static) IP address assigned to you by your ISP for the WAN interface.
Enter the subnet mask assigned to you by your ISP (if given) for the WAN
interface.
Type the IP address of the gateway device (if given).
Enter the login user name assigned to you by your ISP.
Enter the password associated with the user name above.
Enter C (Connect on demand) when you don't want the connection up all the time
and specify an idle time-out in the Max. Idle Timeout Setting field. This is the
default selection.
Enter K (Keep alive) when you want your connection up all the time and specify the
redial time in the Redial Period field to set how long the VSG waits before trying to
bring up the connection automatically if it is disconnected.
The field is only visible when you select K in the Connect Setting field.
Type the time in seconds that elapses before the VSG automatically attempts to
reconnect to the PPTP server. The default is 30 seconds.
Chapter 24 LAN and WAN Setup Using the SMT