VSG-1200 User's Guide
2.2.1.5 The Reset Button
Use a pointed object to press this button in once to reset the VSG back to the factory defaults.
Note: All your custom configuration including the system usernames and
passwords will be erased.
This will NOT delete the subscriber database or the port-location mappings.
2.2.2 Front Panel LEDs
The following table describes the LEDs on the front panel. When turned on, all LEDs are
green unless otherwise specified.
Table 1 Front Panel LEDs
LED
STATUS
PWR
On
Off
ALARM
On (Red)
Blink Once (Red)
Off
LAN or WAN
LK/ACT
On
Blinking
Off
10/100
On
Off
FDX
On
Off
2.2.3 Rear Panel
The power socket, the fan and a ventilation hole are located on the rear panel as shown next.
Note: Do NOT block the ventilation hole.
Figure 7 Rear Panel
36
DESCRIPTION
The VSG is receiving power.
The VSG is not receiving power.
There is a hardware failure.
The system is starting up.
The system is functioning normally.
The port is connected to an Ethernet device.
The port is receiving or sending data.
The port is not connected to an Ethernet device.
The port is operating at 100 Mpbs.
The port is operating at 10 Mpbs.
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
Chapter 2 Hardware Installation and Connection