Tftp File Transfer; Figure 10-5 Menu 24.7.2 - System Maintenance - Upload Router Configuration File - ZyXEL Communications Prestige 316 User Manual

Prestige 316 Broadband Sharing Gateway / Wireless LAN
Menu 24.7.2 - System Maintenance - Upload Router Configuration File
To upload router configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
4. After successful firmware upload, enter "atgo" to restart the
Warning:
1. Proceeding with the upload will erase the current
2. The router's console port speed (Menu 24.2.2) may change
3. When uploading the DEFAULT configuration file, the console
Figure 10-5 Menu 24.7.2 – System Maintenance – Upload Router Configuration File

10.5 TFTP File Transfer

In addition to the direct console port connection, the Prestige supports the up/downloading of the firmware
and the configuration file using TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP should
work over WAN as well, it is not recommended.
To use TFTP, your workstation must have both telnet and TFTP clients. To transfer the firmware and the
configuration file, follow the next procedures:
Step 1.
Use telnet from your workstation to connect to the Prestige and log in. Because TFTP does not
have any security checks, the Prestige records the IP address of the telnet client and accepts
TFTP requests only from this address.
Step 2.
Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System
Maintenance.
Step 3.
Enter command sys stdio 0 to disable the SMT timeout, so the TFTP transfer will not be
interrupted. Enter command sys stdio 5 to restore the five-minute SMT timeout (default)
when the file transfer is complete.
Step 4. Launch the TFTP client on your workstation and connect to the Prestige. Set the transfer mode
to binary before starting data transfer.
10-6
XMODEM upload on your terminal.
router.
configuration file.
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (Menu 23), also.
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed? (Y/N)
Transferring Files