The Qos Policer Setup Screen - ZyXEL Communications P-660HN-51 - V1.10 Manual

Chapter 17 Quality of Service (QoS)

17.6 The QoS Policer Setup Screen

Use this screen to configure QoS policers that allow you to limit the transmission
rate of incoming traffic. Click Advanced > QoS > Policer Setup. The screen
appears as shown.
Figure 99 Advanced > QoS > Policer Setup
The following table describes the labels in this screen.
Table 75 Advanced > QoS > Policer Setup
LABEL
Add new Policer
#
Status
Name
Regulated
Classes
Meter Type
Maximum Rate
Burst Size
Modify
222
DESCRIPTION
Click this to create a new entry.
This is the index number of the entry.
This field displays whether the policer is active or not. A yellow bulb
signifies that this policer is active. A gray bulb signifies that this
policer is not active.
This field displays the descriptive name of this policer.
This field displays the name of a QoS classifier
This field displays the type of QoS metering algorithm used in this
policer.
This field displays the maximum rate configured for the metering
algorithm in the policer.
This field displays the burst size configured for the metering algorithm
in the policer.
Click the Edit icon to edit the policer.
Click the Delete icon to delete an existing policer. Note that
subsequent rules move up by one when you take this action.
P-660HN-51 User's Guide