No Security; Basic (Wep Encryption) - ZyXEL Communications P-660HN-51 - V1.10 Manual

6.2.1 No Security

Select No Security to allow wireless stations to communicate with the access
points without any data encryption or authentication.
Note: If you do not enable any wireless security on your ZyXEL Device, your network
is accessible to any wireless networking device that is within range.
Figure 17 Wireless > General: No Security
The following table describes the labels in this screen.
Table 9 Wireless > General: No Security
LABEL
Security
Level

6.2.2 Basic (WEP Encryption)

WEP encryption scrambles the data transmitted between the wireless stations and
the access points (AP) to keep network communications private. Both the wireless
stations and the access points must use the same WEP key.
Note: WEP is extremely insecure. Its encryption can be broken by an attacker, using
widely-available software. It is strongly recommended that you use a more
effective security mechanism. Use the strongest security mechanism that all the
wireless devices in your network support. For example, use WPA-PSK or
WPA2-PSK if all your wireless devices support it, or use WPA or WPA2 if your
wireless devices support it and you have a RADIUS server. If your wireless
devices support nothing stronger than WEP, use the highest encryption level
available.
Your ZyXEL Device allows you to configure up to four 64-bit or 128-bit WEP keys
but only one key can be enabled at any one time.
P-660HN-51 User's Guide
DESCRIPTION
Choose No Security from the drop-down list box.
Chapter 6 Wireless
81