Add/Edit Static Route - ZyXEL Communications P-660HN-51 - V1.10 Manual

15.2.1 Add/Edit Static Route

Use this screen to add or edit a static route. Click Add new Static Route Entry in
the Routing screen or the Edit icon next to the static route you want to edit. The
screen shown next appears.
Figure 89 Routing: Add/Edit
The following table describes the labels in this screen.
Table 66 Routing: Add/Edit
LABEL
Active
Route Name
Destination IP
Address
IP Subnet
Mask
Gateway IP
Address
Apply
Cancel
P-660HN-51 User's Guide
DESCRIPTION
This field allows you to activate/deactivate this static route.
Select this to enable the static route. Clear this to disable this static route
without having to delete the entry.
Enter a descriptive name for the static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is a router or switch on
the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Chapter 15 Routing
203