Can Change - Ricoh FW770 Operating Instructions Manual

Copy Settings
Settings You Can Change with User Tools
This section is for the key operators in charge of this machine. You can change
or set the machine's default settings.
Note
For how to enter the User Tools program, press the {Clear Modes/Energy Saver}
key, and then press the {Clear/Stop} key for more than 3 seconds.
3
• Fusing Temperature 1–Normal(+01): Selects the fusing temperature for plain
paper.
Note
0: Mode 1, 1: Mode 2, 2: Mode 3, 3: Mode 4, 4: Mode 5, 5: Mode 6, 6: Mode 7
Default: 2
For details about each mode, contact your service representative.
• Fusing Temperature 2–High (+02): Selects the fusing temperature for trans-
lucent paper.
Note
0: Mode 5, 1: Mode 6, 2: Mode 7, 3: Mode 8
Default: 0
For details about each mode, contact your service representative.
• Fusing Temperature 3–Low(+03): Selects the fusing temperature for translu-
cent film.
Note
0: Mode 2, 1: Mode 3, 2: Mode 4, 3: Mode 5
Default: 1
For details about each mode, contact your service representative.
• Count Up/Down(+04): The copy counter can be made to count up or count
down.
Note
0: Count up, 1: Count down
40