Microtek ScanMaker 6400XL Reference Manual page 125

4 SCSI Check SCSI Check
The SCSI Check SCSI Check SCSI Check button acts as a SCSI probe to verify the location of your
scanner and the scanner ID.
When you click on the SCSI check button, the dialog box below appears,
with the scanner and its corresponding SCSI ID displayed in the correct
location. If your scanner does not appear, the connection between your
scanner and PC may not be secure, causing the system not to "see" the
scanner. In this case, check all cables and make sure your scanner is ready.
You may also want to turn the scanner and computer off, wait for 5
seconds, then turn them on again to reset everything.
5 The Reconfigur Reconfigure Equipment Reconfigur Reconfigur Reconfigur
internal reference file and is used if you have changed your setup or
reconfigured your system.
For instance, if you changed scanner models on your system (physically
removed a scanner model and attached a different one), the Scanner model
box (#1) will not show the change automatically unless you first click on
the Reconfigure Equipment button to update the system. Use this feature to
make quick updates; all changes are done internally and automatically.
Your scanner as verified by SCSI check
Click OK to close the dialog box
e Equipment button allows the system to update its own e Equipment e Equipment e Equipment
The Scanner Test Utility B-3