Lubrication - Grizzly G0493 Owner's Manual

lubrication

the bearings are sealed and pre-lubricated and
require no lubrication during their usable life.
however, your saw components will operate at
their best if the bearing surfaces are kept clean—
this is especially important for the trunnion bear-
ings. alWays disConneCt poWer BeFore
doing MaintenanCe!
lubricate the areas indicated below with
general purpose grease every 6–12 months,
depending on frequency of use (see figure
93):
• Blade angling trunnions (can be accessed
from front of machine)
• Bevel gears and leadscrew
• Blade height trunnion
Blade angling trunnion
-48-
Bevel gears
leadscrew
figure 93. lubrication locations (table removed for clarity).
sliding table Ways: spray or wipe on a light
machine oil (such as those shown on page 44)
the entire length of the steel rods (see figure
92).
figure 92. sliding table ways.
Blade height trunnion
g0493 14" sliding table saw
Blade angling trunnion