crosscutting
the Model g0493 can crosscut full size panels
with the fence in the forward or rear position,
although it is easier to load full size panels with
the crosscut fence mounted in the forward posi-
tion (see figure 77).
Forward Mounted
Crosscut Fence
figure 77. Crosscutting full size panel.
Mounting the crosscut fence in the rear position
(figure 78) gives greater stability for crosscutting
smaller panels.
figure 78. Crosscutting smaller panels.
-42-
rear Mounted
Crosscut Fence
lastly, this machine has the capability of cross-
cutting workpieces while using the rip fence as a
cut-off gauge (figure 79).
figure 79. Crosscutting workpieces
using the rip fence as a cut-off gauge.
determine which cutting operation will be best
suited for the workpiece to be crosscut.
— if you will be crosscutting full size panels,
then skip ahead to "Crosscutting Full size
panels."
— if you will be crosscutting smaller panels,
then skip ahead to "Crosscutting smaller
panels."
— if you will be crosscutting workpieces using
the rip fence as a cut-off gauge, then skip
ahead to "Crosscutting using rip Fence as
a Cut-off gauge."
g0493 14" sliding table saw