Grizzly G0493 Owner's Manual page 33

46. With the help of an assistant, place the cross-
cut table on the pivot pin of the swing arm
and slide the t-nut into the t-slot in the slid-
ing table (see figure 53).
sliding t-nut
into t-slot
figure 53. installing the crosscut table.
47. slide two M8-1.25 t-nuts into the crosscut
table brace. align the t-nuts in the crosscut
table brace with the holes in the crosscut
table, and thread the two M8-1.25 x 50
knobs, with two 8mm flat washers, into the
t-nuts as shown in figure 54.
Crosscut
table Brace
figure 54. installing the crosscut table brace.
g0493 14" sliding table saw
48. install the components shown in figure 55
on the crosscut fence.
Flip stops
t-Bolt
t-nut, Fiber Washer & Center stud
figure 55. Crosscut fence assembly.
49. position the center stud and the t-bolt over
the placement holes shown in figure 56,
then tighten the center stud.
Center stud
placement
figure 56. Crosscut fence placement.
50. thread the M8-1.25 knob with an 8mm flat
washer onto the t-bolt to secure the crosscut
fence.
51. slide the blade guard/dust hood over the
riving knife, and attach it with an M8-1.25 x
40 button head cap screw and an 8mm flat
washer.
52. (optional) if needed, slide the edge shoe and
hold down clamp into the table t-slot, and
tighten the respective knob/handle. position
where necessary. (the front cover picture
shows these items installed.)
M8-1.25 X 25
KnoB
t-nut, Block,
lock Washer,
Cap screw
t-Bolt
placement
-31-