Table of Contents
Advertisement
17. thread an M10-1.5 hex nut all the way onto
two M10-1.5 x 20 cap screws, then install the
cap screws where shown in figure 35 to hold
the small extension table level. tighten the
hex nuts against the table support to lock the
cap screws in place.
figure 35. small extension table support cap
screws (table removed for photo clarity).
18. Mount the scale bar to the cast iron table and
large extension table, making sure it is even
with the top of the tables. use the three M6-1
x 25 hex bolts, three 6mm flat washers, three
6mm lock washers, and three M6-1 hex nuts,
as shown in figure 36, to mount it. (the top
of the hex bolts slide into the scale bar.)
figure 36. attaching the scale bar.
-26-
19. pre-assemble each of the four rail studs with
a 12mm flat washer and two M12-1.75 hex
nuts, then thread them into the round rail, as
shown in figure 37.
figure 37. installing studs with hardware into the
round rail.
20. insert the studs into the tables as shown in
figure 38. put a 12mm flat washer, 12mm
lock washer and a M12-1.75 hex nut on the
end of each stud to hold the round rail on
the tables. do not tighten the hex nuts at this
time.
figure 38. installing the round rail.
g0493 14" sliding table saw
Advertisement
Table of Contents
