Moving & Placing Base Unit - Grizzly G0493 Owner's Manual

moving & placing
base unit
the model g0493 is a
heavy
weighs over 1300 lbs.
serious personal injury
may occur if safe mov-
ing methods are not fol-
lowed. to be safe, you
will need assistance and
power equipment when
moving
crate and removing the
machine from the crate.
use lifting straps with a minimum of 1500
lbs. lifting capacity. if the lifting strap breaks,
serious personal injury may occur.
to remove the saw base unit from the crate
pallet:
1.
remove the top of the crate and position the
forklift forks together and directly above the
saw.
2. place two lifting straps over the forks and
attach the ends to the lifting bolts as shown
in figure 19.
figure 19. lifting the saw base unit.
-22-
machine that
the shipping
do not lift the table saw any higher than
necessary to clear the floor. serious per-
sonal injury and damage to the machine
may occur if safe moving methods are not
followed.
3. lift the saw base unit and move it to your
predetermined location.
4.
Before lowering the saw into position, place
safety blocks under the frame and thread the
four feet into the frame at least half of the
length.
5.
remove the safety blocks and lower the saw
onto the feet as shown in figure 20 and
remove the forklift straps.
figure 20. Foot installed in cabinet leg.
6. place a level on the saw table and adjust the
feet so the saw table is level from left-to-right
and from front-to-back. this will allow the
table to slide smoothly.
7. lock the feet in position by tightening the two
hex nuts together against the cabinet leg.
g0493 14" sliding table saw