Table of Contents
Advertisement
21. slide the rip fence body onto the round rail.
thread the lock handles M10-1.5 x 12 and
knob M10-1.5 x 70 into the rip fence body,
where shown in figure 39.
lock handles
M10-1.5 x 12
figure 39. rip fence handles.
22. slide the aluminum rip fence onto the clamp-
ing plate as shown in figure 40, and lock it
with the fence lock handle.
Clamping
plate
figure 40. installing the rip fence.
23.
open the motor compartment and
the red shipping braces from both motors,
then re-install the shipping brace fasteners
back into the holes from which they came.
24. Move the blade arbor tilt to 0˚ and raise it as
far as it will go.
g0493 14" sliding table saw
Knob
M10-1.5 x 70
Fence lock
handle
remove
25. install the flat belt on the scoring motor and
arbor pulley as shown in figure 41.
note: The scoring motor adjusts by lifting it
up. The weight of the scoring motor dictates
the correct belt tension.
Flat Belt
figure 41. Flat belt installed on scoring motor
and arbor pulley (table removed for clarity).
26. slide the table all the way forward to access
the blade arbor and pull open the blade guard
(see figure 42).
Main Blade
arbor
figure 42. Main blade arbor components.
-27-
Advertisement
Table of Contents
