Grizzly G0493 Owner's Manual page 32

39. Move the rip fence against the main blade (or
scoring blade) as shown in figure 49.
figure 49. Fence used to align blades.
40. adjust the scoring blade, using the horizontal
adjustment controls, until the rip fence evenly
touches both blades.
41. Move the rip fence against the blades again.
loosen the screws securing the scale bar,
line up the 0" mark on the scale with the left
edge of the rip fence, then tighten the scale
bar mounting screws.
42. set the rip fence to
ring with set screw on the round rail against
the fence housing. Without moving the ring,
move the fence housing out of the way, and
secure the set screw on the ring, as shown
in figure 50. When installed correctly, this
ring will prevent the fence from contacting the
blade.
adjustable ring
w/set screw
figure 50. securing the adjustable ring.
-30-
⁄ ", slide the adjustable
1
8
43. Move the blade guard back to its original
position, and move the sliding table back to
center.
44. place the end washer (figure 51) on the end
of the round rail and secure it with the M8-
1.25 x 16 cap screw and 8mm lock washer.
end Washer
figure 51. end washer on round rail.
45. thread the M12-1.75 x 55 adjustable handle,
with a 12mm flat washer, through the cross-
cut table and into a M12-1.75 t-nut as shown
in figure 52.
figure 52. installing the adjustable handle.
g0493 14" sliding table saw