Table of Contents
Advertisement
if the machine does not operate as stated
in this section, review the troubleshooting
section on page 47. if you need additional
help, call tech support at (570) 546-9663.
do not place a machine into regular oper-
ation if you suspect that it is malfunctioning
or serious injury could occur.
to test run the saw:
1.
put on safety glasses, make sure any bystand-
ers are out of the way, and that all tools have
been removed from the saw.
2.
insert the key into the power switch and turn
it clockwise.
3.
push in, then rotate both emergency stop
switches clockwise until they pop out. this
resets the emergency stop switches so the
machine can operate.
4.
one at a time, press the blade on buttons.
the blades should startup and run smoothly
without any problems.
—if any problems occur, press the nearest
emergency stop switch.
5.
one at a time, press the blade oFF buttons.
the blades should stop running. as the main
blade comes to a stop, watch the direction
that it is spinning.
—if the main blade is rotating counterclock-
wise, disconnect the saw from power and
exchange wires r & t in the power con-
nection box.
6.
depress the #1 emergency stop switch.
-34-
7.
press the blade on buttons. nothing should
happen.
—if the stop switch is working correctly, reset
the switch.
8.
repeat steps 6–7 with the #2 emergency
stop switch.
9.
Make sure both emergency stop buttons are
reset before continuing.
10. open the cabinet door at the rear of the
machine. this opens the limit switch at the
door.
11. press the blade on buttons. nothing should
happen.
12. Close and latch the cabinet door.
13. turn the key switch off and disConneCt
saW FroM poWer!
14. Move the sliding table all the way forward,
then open the orange blade guard. this
opens the blade guard limit switch.
15. Connect the saw to the power source and
turn the power switch key on.
16. (during this step, be prepared to immediately
press the #1 emergency stop switch if the
blades start operating.) press the blade on
buttons. nothing should happen.
17. turn the key switch off and disConneCt
saW FroM poWer!
18. Close the orange blade guard and move
the sliding table back to the center of the
machine.
g0493 14" sliding table saw
Advertisement
Table of Contents
