Power Connection; Test Run - Grizzly G0493 Owner's Manual

power connection

Before connecting the saw to power, read through
section 2: circuit reQuirements to
check that your setup follows the safety and circuit
requirements for this machine.
to connect the saw to the power source:
1.
open the power connection box shown in
figure 60.
power Connection Box
figure 60. power connection box.
2. Connect the power wires to the terminals
shown in figure 61, tighten the strain relief
so the wires can't be pulled from the termi-
nals, then close the power connection box.
note: When using a phase converter, con-
nect the manufactured power leg to the S
terminal to prevent damage (see Page 13).
r s t
figure 61. Main terminal box.
g0493 14" sliding table saw
ground

test run

after the machine has been connected to the
power source, the machine Must be test run to
make sure all the controls are working properly.
the test run includes verifying that the safety
disabling components on the machine work cor-
rectly.
Before beginning the test run, review the controls
shown in figures 62 & 63.
Blade on Buttons
power switch
power light
Blade oFF Buttons
figure 62. Main power controls.
#2 emergency stop switch
figure 63. emergency stop switch #2.
#1 emergency
stop switch
-33-