Transponder Mode Selection - Garmin G1000:Socata Pilot's Manual

AUDIO PANEL AND CNS
XPDR1
0
Selecting and activating Transponder 1 or Transponder 2:
1) Select the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Select the XPDR1 or XPDR2 Softkey to select and activate the other transponder.
When turning on the G1000 for use, the system activates Transponder 1 as the default unit, regardless of
which transponder was active prior to shutdown. When switching between Transponder 1 and Transponder 2,
the code and mode remain the same. If a new code is entered in the active transponder, switching transponders
does not bring back the previous code.

TRANSPONDER MODE SELECTION

Mode selection can be automatic (Ground and Altitude Modes) or manual (Standby, ON, and Altitude Modes).
The STBY, ON , and ALT Softkeys can be accessed by selecting the XPDR Softkey.
Selecting a transponder mode:
1) Select the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Select the desired softkey to activate the transponder mode.
4-30
XPDR2 STBY ON ALT
1 2 3 4
Figure 4-35 Transponder Softkeys (PFD)
Garmin G1000 Pilot's Guide for the Socata TBM 850
XPDR IDENT
GND VFR CODE IDENT
Selecting the BACK Softkey
returns to the top-level softkeys.
5 6 7 IDENT
Selecting the BACK Softkey returns to the mode selection softkeys.
MSG
BACK
MSG
BKSP BACK
190-00709-00 Rev. A