Garmin G1000:Socata Pilot's Manual page 511

MISCELLANEOUS MESSAGE ADVISORIES
Message
FPL WPT LOCK – Flight plan waypoint
is locked.
FPL WPT MOVE – Flight plan
waypoint moved.
TIMER EXPIRD – Timer has expired.
DB CHANGE – Database changed.
Verify user modified procedures.
DB CHANGE – Database changed.
Verify stored airways.
FPL TRUNC – Flight plan has been
truncated.
LOCKED FPL – Cannot navigate
locked flight plan.
WPT ARRIVAL – Arriving at waypoint
-[xxxx]
STEEP TURN – Steep turn ahead.
INSIDE ARSPC – Inside airspace.
ARSPC AHEAD – Airspace ahead less
than 10 minutes.
ARSPC NEAR – Airspace near and
ahead.
ARSPC NEAR – Airspace near – less
than 2 nm.
APR INACTV – Approach is not active. The system notifies the pilot that the loaded approach is not active. Activate
SLCT FREQ – Select appropriate
frequency for approach.
SLCT NAV – Select NAV on CDI for
approach.
PTK FAIL – Parallel track unavailable:
bad geometry.
190-00709-00 Rev. A
Comments
Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an aviation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this message.
This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
Or
update the waypoint name/identifier to reflect the new information.
The system has detected that a waypoint coordinate has changed due to a new
aviation database update. Verify that stored flight plans contain correct waypoint
locations.
The system notifies the pilot that the timer has expired.
This occurs when a stored flight plan contains procedures that have been manually
edited. This alert is issued only after an aviation database update. Verify that the
user-modified procedures in stored flight plans are correct and up to date.
This occurs when a stored flight plan contains an airway that is no longer consistent
with the aviation database. This alert is issued only after an aviation database update.
Verify use of airways in stored flight plans and reload airways as needed.
This occurs when a newly installed aviation database eliminates an obsolete approach
or arrival used by a stored flight plan. The obsolete procedure is removed from the
flight plan. Update flight plan with current arrival or approach.
This occurs when the pilot attempts to activate a stored flight plan that contains
locked waypoint. Remove locked waypoint from flight plan. Update flight plan with
current waypoint.
Arriving at waypoint [xxxx], where [xxxx] is the waypoint name.
A steep turn is 15 seconds ahead. Prepare to turn.
The aircraft is inside the special use airspace.
Special use airspace is ahead of aircraft. The aircraft will penetrate the airspace within
10 minutes.
Special use airspace is near and ahead of the aircraft position.
Special use airspace is within 2 nm of the aircraft position.
approach when required.
The system notifies the pilot to load the approach frequency for the appropriate NAV
receiver. Select the correct frequency for the approach.
The system notifies the pilot to set the CDI to the correct NAV receiver. Set the CDI to
the correct NAV receiver.
Bad parallel track geometry.
Garmin G1000 Pilot's Guide for the Socata TBM 850
APPENDIX A
A-17