How To Update Charts - Furuno MFD12 Operator's Manual

13. How to Adjust Settings
13.7.2

How to Update Charts

You can update the charts that you have on your hard disk from the NavNet web site
www.navnet.com. Follow "How to copy system information to a SD card" on page 8-6
then do the following.
1. Put the SD card that contains the chart data into one of the slots in the card drive.
2. Press the MENU key to open the menu.
3. Open the [Chart-Data Catalog] menu.
4. Rotate the RotoKey to select the [Install data from SDcard] button then push the
RotoKey. The message shown below appears.
5. Rotate the RotoKey to select Yes then push the key. The application quits and
chart loading starts. A progress bar shows loading progress.
Note: Do not remove an SD card or turn off the power while a chart is being load-
ed. Loading can take a long time depending on the amount of data to be loaded.
When loading is completed, a message indicating completion appears.
6. When the loading is completed, your NavNet 3D automatically restarts itself. After
the equipment has completed the start-up, the message "Installation is successful
for 1 area. No further action is required." appears. Push the RotoKey to start op-
eration.
For fee-type chart, the message "Installation is successful for 1 area. But 1 area
need a valid Unlock Code. Please, go to Charts Catalog menu page to enter miss-
ing Unlock Code (s)." appears. If this occurs, contact your dealer for advice.
13-24
Application will now exit to perform data installation. Do you want
to continue?