Furuno MFD12 Operator's Manual page 219

13. How to Adjust Settings
4. Select how to show the data in the data box.
Off: Turn off the data.
Single: Display data individually.
Split: Display two items per box. For example, SOG and COG show both of those
data in one box. ("Pos" is a special example, because it is a two-line display.)
5. Use the RotoKey to select the [Data Box Value] combo box related to the data
box number selected at step 3.
6. Use the RotoKey to select or remove the data.
7. Set the #2, #3 and #4 data boxes and the cursor data box by the same method.
8. If you have some boxes that are set for a split display, select the amount of time
to show each data. Select [Scrolling Time Delay] then push the RotoKey.
9. Use the RotoKey to select the amount of time to display each data pair.
10. If you have a wind sensor, you can select to display wind value in speed over
ground (SOG) or speed through water (STW) when changing to Apparent Wind
indication from True Wind. Use the RotoKey to select [True Wind Reference].
11. Use the RotoKey to select SOG or STW. (In case of wind data fed from the FU-
RUNO FI-50 series, STW is used when there is no heading data, regardless of
this setting.)
12. Press the MENU key to close the menu.
13-8
SOG
STW