Denon AVR-4310CI Owner's Manual page 62

Tuning in Radio Stations – SIRIUS Satellite Radio
Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT> ENTER
<TUNING PRESET>
uio p <STATUS>
[ SAT TU]
[TU ]
d
[A ~ G]
[TU ]
f
[MEMO]
[SEARCH]
uio p
ENTER
[SOURCE
SELECT]
(MAIN mode)
[CHANNEL]
[0 ~ 9]
[SAT TU]
(MAIN mode)
[SHIFT]
Sub remote control unit

Checking the SIRIUS Signal Strength and Radio ID
1
Press <STATUS>
display.
BUTTON
The display will switch as shown below, depending on the
<BUTTON>
reception conditions.
[BUTTON]
Display
EXCELLENT
GOOD
WEAK
NO SIGNAL
2
Adjust the position of the antenna until "SIGNAL:
EXCELLENT" is shown on the display.
3
<STATUS>
Press
"SR001") is displayed.
4
Press [TU
Channel No. and Sirius ID are alternately shown on the display.
SR000 SiriusID
************
[ DTU]
b Write your own SIRIUS ID for storage use.
[A ~ G]
Sirius ID :
[TU ]
d
[TU ]
f
The strength of both the SIRIUS satellite and terrestrial signals can be
[MEMO]
checked "Antenna Aiming" (vpage 52).
[MODE]
[BAND]
uio p
[CHANNEL]
[SOURCE
SELECT]
(MAIN mode)
[1 ~ 8]
[DTU]
(MAIN mode)
[DTU]
[SAT TU]
until "SIGNAL" appears on the
Status
Signal strength is excellent
Signal strength is good
Signal strength is weak
No signal
until the channel (example:
] or [TU ] and select channel 0 (SR000).
d f
Sirius ID
Presetting Radio Channels (Preset Memory)
Your favorite broadcast channels can be preset so that you can tune
them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
[MEMO]
Press .
3
[A ~ G]
Press to select the block in which the channel
[CHANNEL]
is to be preset, then press
select the preset number.
The memory block can also be selected by pressing
b
the sub-remote unit.
4
Press [MEMO] again to complete the setting.
To preset other channels, repeat steps 1 to 4.
NOTE
Preset channels are erased by overwriting them.
Listening to Preset Channels
[CHANNEL]
Press to select the desired preset channel,
then press ENTER .
[1
Selection is still possible if you press ~
b
G]
.
You can also operate via the main unit. In this case, perform the
following operations.
<TUNING PRESET> <SOURCE SELECT>
Press , then turn
preset radio channel.
[1 ~ 8]
or to
[SHIFT]
on
8] [A
after pressing ~
to select the