Denon AVR-4310CI Owner's Manual page 34

Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey Auto Setup)
STEP3 Measurement
2
Move the setup
microphone to
position 2, select
"Measure", and then
press ENTER .
The measurement of the
2nd position starts.
To skip this step, select "Next → Calculation" and proceed to
b
STEP4 .
3
Repeat step 2,
measuring positions
3 ~ 8.
When measurement of
position 8 is completed,
a "Measurements
finished." message is
displayed.
To skip this step, select "Next → Calculation" and proceed to
b
STEP4 .
Measure in at least 6 positions in and around the main listening
b
position. Even though you can complete measurement with at
least 6 positions, it is advisable to use more than 6 (a maximum
of 8 positions).
STEP4 Calculation
4
On the STEP3
screen, select "Next
→ Calculation", and
then press ENTER .
Measuring results
are analyzed, and the
frequency response
of each speaker in
the listening room is
determined.
b Analysis takes several minutes to complete. The time required for
this analysis depends on the number of speakers connected.
The more connected speakers there are, the longer it takes to
perform analysis.

Main remote control
operation buttons
STEP5 Check
5
On the
screen, press
to select the item you
want to check, and
ENTER
then press
Speaker Config. Check
Distance Check
Channel Level Check
Crossover Freq. Check
Subwoofers may measure a greater reported distance than
b
the actual distance due to added electrical delay common in
subwoofers.
6
Press to select the channel you want to check.
ui
The measurement result of each speaker is displayed.
If you want to check another item, press
b
Select "Next → Store" and press
b
STEP6 Store
7
Select "Store" and
then press ENTER
Save the measuring
results.
The save operation
b
takes about 30 seconds
to complete.
NOTE
During saving of measuring results, be sure not to turn off the
power.
8
When the
shown on the right
appears, unplug the
setup microphone
from the AVR-4310CI
SETUP MIC jack.
9
Select "Exit" and then press
:Displaying the menu
Cancel the menu
STEP5
ui
.
RETURN
.
ENTER
to proceed to " STEP6 ".
.
screen
ENTER .
:Moves the cursor
(Up/Down/Left/Right)
Exiting the GUI Menu
n
MENU
Press while the GUI menu is displayed.
The GUI menu display disappears.
NOTE
After performing Audyssey Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey Auto Setup again.
• If there is a disparity between the results and the connection status,
or if an error message is displayed, check the error message against
the errors listed in the "Error Messages" section (vpage 32) and
perform Audyssey Auto Setup again.
• If the result still differs from the actual connection status after
remeasurement or the error message still appears, it is possible
that the speakers are not connected properly. Turn the AVR-4310CI
off, check the speaker connections and repeat the measurement
process from the beginning. Turn the AVR-4310CI off, check the
speaker connections and repeat the measurement process from the
beginning.
• If you change a speaker position or orientation, perform Audyssey
Auto Setup again to obtain optimal equalizer correction.
:Confirm the setting :Return to previous menu