Presetting Radio Channels (Preset Memory)
Your favorite broadcast channels can be preset so that you can tune
them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast channel you want to preset.
2
Press
[MEMO]
.
3
[A ~ G]
Press
to select the block in which the channel
is to be preset, then press
[CHANNEL]
select the preset number.
The memory block can also be selected by pressing
b
the sub-remote unit.
4
Press
[MEMO]
again to complete the setting.
To preset other channels, repeat steps 1 to 4.
NOTE
Preset channels are erased by overwriting them.
Listening to Preset Channels
1
[A ~ G]
Press
to select the memory block.
2
[CHANNEL]
[1 ~ 8]
Press
or
to select the desired
preset channel.
You can also operate via the main unit. In this case, perform the
following operations.
<TUNING PRESET>
<SOURCE SELECT>
Press
, then turn
preset radio channel.
Searching Categories
1
Press
o p
.
2
Use
o p
to select the category, to use
the desired channel.
or
[1 ~ 8]
to
Accessing XM Radio Channels Directly
1
[SEARCH]
Press
.
[SHIFT]
on
2
Press
[0 ~ 9]
to input the channel.
Example: Accessing channel "XM123": Press
If no button is pressed within several seconds, the channel
b
automatically switches to the one whose number has been input.
3
ENTER
Press
to set that channel.
Reception switches to the selected channel.
•
"LOADING" is displayed while channels or data are being received.
•
Refer to "Troubleshooting" – "XM Satellite Radio" (vpage 111)
regarding other messages.
to select the
Tuning in Radio Stations – XM Satellite Radio and SIRIUS Satellite Radio
Listening to SIRIUS Satellite Radio
When operating SIRIUS with the AVR-4310CI via the main remote
control unit or sub remote control unit, use
Before operating, set to
[SAT TU]
Channel category
of
mode can use only either XM or SIRIUS. The default setting is for
ui
to select
SIRIUS operation.
1
Set GUI menu "Option Setup" – "Remote (SIRIUS/
XM)" (vpage 44) to "SAT TU : SIRIUS".
2
Press
Select menu, then select "
The input source becomes that set in step 1.
3
Set the main remote control unit to the "SAT TU"
[1]
[2]
[3]
,
and
.
mode (vpage 89 "Operating the Main Remote
Control Unit").
You can then operate the input source you set in step 1.
4
Use
[TU
When the channel is tuned in, the name of the song and artist
are displayed.
5
Adjust the items below.
n
Adjusting the master volume
Selecting the surround mode
n
n
Adjusting the Sound and Picture Quality
(vpage 73)
•
The channel switches continuously when
and held.
•
The song title, artist name, composer name, category and reception
level can be checked by pressing
•
The time (default : 30 sec) for which the GUI menu are displayed can
be set "GUI" – "Tuner" (vpage 43). Press
the original screen.
[SAT TU]
.
[SAT TU]
operating mode.
[SOURCE SELECT]
[SAT TU]
[DEVICE SELECT]
and
of
[SOURCE SELECT]
to display the GUI Source
" (vpage 27).
]
or
[TU
]
to select the channel.
d
f
(vpage 70)
(vpage 71)
[TU
]
[TU
or
d
f
<STATUS>
.
uio p
]
is pressed
to return to
8