Connecting The Ipod; Connecting The Rs-232C Terminal; Connecting The Trigger Out Jacks; Connecting The Multi Zone Terminals - Denon AVR-2807 Operating Instructions Manual

Denon avr-2807: operating instruction
Hide thumbs Also See for AVR-2807:
Table of Contents

Advertisement

Connecting Other Sources
®

Connecting the iPod

When using an iPod, you must connect the DENON original Control Dock for iPod and the DOCK
CONTROL jack on the AVR-2807 with a mini-jack and assign the iPod to any AUDIO and/or S-
VIDEO terminal(s).
The diagram below shows an example of connections for when the iPod is assigned to the VDP
terminal.
For instructions on assigning the iPod to a specific terminal, see
"Setting the iPod Assignment" (
For instructions on playing the iPod, see "Playing the iPod" (
page 39).
• The optional standard Control Dock for iPod is DENON ASD-1R sold separately.

Connecting the RS-232C terminal

page 47).
ASD-1R
A
R
L
AUDIO OUT
G
S-VIDEO OUT
This is a control expansion terminal for
factory use only. Consult you dealer for
details.
Perform the following operation before
using an external controller connected to
the RS-232C terminal:
1. Press the ON/STANDBY button on the
main unit and set the unit to the
operating mode.
2. Perform the operation to turn off the
power from the external control.
3. Check that the product has been set
to the standby mode.
After checking the above, check the
connections of the external controller.
Operation is possible.

Connecting the TRIGGER OUT jacks

iPod

Connecting the MULTI ZONE terminals

For instructions on operations using the MULTI ZONE functions (
R
L

ZONE2 out connections

• If another pre-main (integrated) amplifier is connected, the ZONE2 out (fixed level) terminals can
be used to play a different program source in ZONE2 the same time (
Extension terminal
for future use.
• For the AUDIO output, use high quality pin-plug cables and wire in such a way that there is no
humming or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices'
operating instructions.
21
Connecting Other Sources
Turn the DC 12 V voltage on and off for
the individual functions and surround
modes.
For details, see "Setting the Trigger Out"
(
page 55).
page 40, 41).
page 40).
Input
Output
+
+
AUX OUT
RC-616
RC-617
Infrared retransmitter
Infrared sensor
Monitor
(ZONE2)
G
S-VIDEO
IN
F
VIDEO
IN
Premain amplifier
(ZONE2)
A
L
L
L
IN
R
R
R

Advertisement

Table of Contents
loading

Table of Contents