Setting The Learning Function; Using The System Call Function; Registering; Operating - Denon AVR-2807 Operating Instructions Manual

Operating the remote control unit
[POWER OFF]
1
[ ]
[SYSTEM CALL]
[USE/LEARN]

Setting the learning function

• If your AV device is a brand other than DENON or if operation is
not possible using the preset memory function, the signals of a
remote control unit of that device can be stored in the AVR-
2807's remote control unit.
• For some remote control units, it may not be possible to learn
the signals or the device may not operate properly after the
signals are learnt. In this case, use the remote control unit of
that device.
1
[USE/LEARN]
Press with the tip of a pen etc., to
set the learn mode.
• [MODE SELECTOR] and the "LEARNED/TX" indicator blinks.
2
[MODE SELECTOR]
Press for the device to be
operated.
• [MODE SELECTOR] and the "LEARNED/TX" indicator blinks.
3
Press the button to be set.
[ON/SOURCE] • The "LEARNED/TX" indicator stops blinking and [MODE
SELECTOR] lights.
If a button that cannot be learnt is pressed, [MODE SELECTOR]
and the "LEARNED/TX" indicator blinks.
4
Point the remote control units straight at each
other and press and hold in the button on the
other remote control unit to be learnt on the
AVR-2807's remote control unit.
5 [MODE SELECTOR]
indicator lights, release the button on the other
remote control unit.
• [MODE SELECTOR] and the "LEARNED/TX" indicator blinks
again.
Other buttons can be learnt by repeating steps 2 ~ 5.
6
[USE/LEARN]
Press
• To cancel the learning function mode, press [USE/LEARN].
• If the codes could not be stored, the "LEARNED/TX" indicator
start flashing rapidly. For limited number of models, codes
cannot be stored in RC-1030.
• If [MODE SELECTOR] and the "LEARNED/TX" indicator start
flashing rapidly, this means that the memory is already full, and
the code you have just attempted to store was not stored.
To "learn" that code, first perform the resetting operation (
page 65).
Other remote control unit
The AVR-2807's remote control unit
(RC-1030)
and the "LEARNED/TX"
.
64
Operating the remote control unit

Using the system call function

• A series of operations can be registered at a single button.
• This function makes it possible to for example turn the
amplifier's power on, select the input source, turn the monitor
power's on, turn the source device's power on and start
playback, all by pressing a single button once.
• Up to 10 signals each can be stored at [SYSTEM CALL] (1 or 2).

Registering

1
[ON/SOURCE] [POWER OFF]
Press and
same time.
• The "LEARNED/TX" indicator blinks.
2
[SYSTEM CALL 1]
Press for which you want to
register the operations.
• [MODE SELECTOR] and the "LEARNED/TX" indicator blinks.
3
[MODE SELECTOR]
Press for the device to be
operated.
4
Press the buttons you want to register in the
order of the operations to be performed.
Example: Press [ON].
↓ ↓
Press [CD] of [MODE SELECTOR].
↓ ↓
Press [ 1 ].
Repeat steps 3, 4 to register the desired buttons.
5
[SYSTEM CALL] 1 2
Press ( or

Operating

[SYSTEM CALL] 1 2
Press ( or ) at which the operation
are registered.
• The stored signals are transmitted successively.
at the
).