Setting The Volume Control; Setting The Trigger Out - Denon AVR-2807 Operating Instructions Manual

Advanced Setup – Part 1

Setting the Volume Control

This sets the volume level of output.
1
D D H H
Press to select "Volume Control", then press
ENTER
.
2 D D H H
Press to select the item, then press
set.
Vol. Limit:
Set the volume's upper limit.
• OFF:
If you do not want to set a volume limit, select "OFF".
In this case, the volume can be set to the AVR-2807's
maximum volume (output) level of +18 dB, which is
extremely loud.
• –20 dB, –10 dB, 0 dB:
The volume cannot be increased above the selected levels.
P. On Lev.:
Set the volume level when the power is turned on.
You can adjust the MAIN ZONE volume level within the range
of –80 to +18 dB (and ZONE2 volume level within the range
of –70 to +18 dB).
• LAST
The volume set when the AVR-2807 was last used is stored
in the memory and set when the power is turned on.
• – – – (Mute)
The volume is always muted when the power is turned on.
Mute Lev.:
Set the level of volume attenuation in the mute mode.
• FULL
The volume is fully muted.
• –20 dB, –40 dB
The volume is lowered 20 dB (or 40 dB) from the current level.
3
ENTER
Press .
1
F F G G
to
• When the power amplifier is assigned to either of the ZONE2
channels at "Power Amp Assign", "–VAR–" (only variable) is
displayed and the fixed level cannot be set.

Setting the Trigger Out

Use the DC12V output of the AVR-2807's 2 trigger out jacks in
association with the various input sources and surround modes.
If "ZONE = MAIN" is selected, settings can be made for the
individual surround modes.
1 D D H H
Press to select "Trigger Out", then press
ENTER
.
2 D D H H
Press to select the trigger out jacks, then
ENTER
press .
3
F F G G
Press to select "MAIN" or "ZONE2".
The power supplied from the trigger out jack turns on and off
when the power for the set zone is turned on and off.
4
2
ON, OFF:
5
ON:
OFF:
6
1
4
55
Advanced Setup – Part 1
D D H H
Press to select the input source, then press
G G
to set.
When that input source is selected, the power supplied from
the trigger out jack turns on (or off).
When "MAIN" was selected at step 3:
D D H H
Press to select the surround mode, then
F F G G
press to set.
If "ON" is selected when an input source set to "ON" is
selected, the power supplied from the trigger out jack turns
on.
If "OFF" is selected when an input source set to "ON" is
selected, the power supplied from the trigger out jack turns
off.
ENTER
Press .
2
3
5
F F