Operating The Remote Control Unit; Operating Denon Audio Components; Setting The Preset Memory Function - Denon AVR-2807 Operating Instructions Manual

Operating the remote control unit

[POWER OFF]
[MODE SELECTOR]
[MODE SELECT]
• It may not be possible to use some of the buttons, depending
on the model and age of your equipment.

Operating DENON audio components

[LEARNED/TX]
1
[ON/SOURCE] [MODE SELECTOR]
Press
the device to be operated.
• The button for the selected mode lights.
The mode switches as shown below each time [MODE
SELECT] is pressed:
CD
ZONE2
2
Operate the component.
For details, refer to the component's operating instructions.

Setting the preset memory function

The various devices can be operated by setting the preset
memory on the included remote control unit.
For some models the remote control unit or the device may not
operate properly. In this case, use the learning function (
page 64) to store your device's remote control signals in the
included remote control unit.
1
[ON/SOURCE]
Press
same time.
• The "LEARNED/TX" indicator blinks.
2
[MODE SELECTOR]
Press
in the preset memory.
• [MODE SELECTOR] and the "LEARNED/TX" indicator blinks.
3 Input the (4-digit) number for the brand of the
device to be set in the preset memory, as shown on
the list of preset codes (
• When stored correctly, [MODE SELECTOR] and the
"LEARNED/TX" indicator lights.
[MODE SELECT]
or
CDR/MD TAPE DVD/VDP
TV DBS/CABLE VCR
[POWER OFF]
and at the
for the device to be set
End of this manual).
62
Operating the remote control unit
• There may be several preset codes for some brands. If the
for
remote control unit does not work properly with one code, try
inputting another code.
• Buttons that have been learned have priority over the signals
set with the preset memory function. If a learned button setting
is not needed, please erase it (
NOTE:
• The preset memory can be set for one component only
among the following: CDR/MD, DVD/VDP and DBS/CABLE.
page 65).