Preliminary Measurements; Speaker Measurements - Denon AVR-2807 Operating Instructions Manual

Easy Setup Procedure
y Preliminary measurements
This procedure is used to automatically determine the
background noise, whether or not speakers are connected, and
the polarities of the connected speakers.
1
D D H H
Press to select "Start", then press
• The preliminary measurements start.
2 D D H H
Press to select "Speaker Detect Check", then
ENTER
press .
3
ENTER
Press again.
1
2
h h
(Screen after initial measurement)
h h
(After measurement
completed)
• If the results are not as expected or if an error message is
displayed, select "Retry" and perform the measurements again
( page 12).
• If the results of remeasurement are still not as expected or if an
error message is displayed, turn off the power switch and
check the speaker connections. Then start the measurements
again from the beginning.
Cautions during measurements:
• Loud test tones are output during the measurements. Be
careful for example when small children are nearby.
• Proper measurements may not be possible if there are
obstacles between the speaker and the setup microphone.
• During the measurements, do not stand between or near
F F
the speakers and setup microphone.
.
• To avoid influencing the measurements, turn off the power
of air-conditioners or any other equipment producing sound
in the room. Perform the measurements with the room as
quiet as possible.
• Measurement is cancelled when VOLUME is operated while
the Auto Setup is performed.
u Speaker measurements
With these measurements, the "Speaker Configuration",
"Distance", "Channel Level", "Crossover Frequency" and
"Room EQ" settings are analyzed automatically. The main
listening position is measured first, so leave the microphone
where it is.
1
D D H H
Press
• Measurements for the first point start.
(Press ENTER.)
2
Move the microphone to the second point and
F F
press .
• Measurements for the second point start.
Once the measurements are finished, the results of the
measurements for the second point are displayed.
3
Perform step 2 repeatedly.
Measurements can be ended when there are 6 or less
measurement locations; however, to obtain better results,
measurements at 6 locations is recommended.
F F
to select "OK Start", then press
11
4
D D H H
Press to select "Calculate", then press
• The speaker is analyzed.
Once the calculations are completed, a screen for
confirming the results of the measurements appears.
The amount of time required for the analysis depends on the
number of speakers and the number of measuring points.
The greater the number of speakers and measuring points,
the longer the time required.
1
2
h h
4
.
h h
(After completion of
measurement for first point)
NOTE:
• Do not change the speaker connections or subwoofer
volume after making the measurements.
Easy Setup Procedure
F F
.
h h