Connecting Other Sources
Connecting a CD player
To connect the digital audio output from the CD player, you can choose from either the coaxial or
optical connections. If you choose to use the optical connection, it needs to be assigned. For more
information about Digital Input Assignment (
Connecting a turntable
You can connect the turntable (MM cartridge) to the PHONO terminals.
NOTE:
• The phono input can accept signals from moving magnet (MM) and high output moving coil
(MC) phono cartridges. If your turntable is equipped with a low output MC cartridge, you will
need to use a separate MC head amplifier or step-up MC transformer.
• If humming or other noise is generated when the ground wire is connected, disconnect the
ground wire.
page 63).
CD player
AUDIO OUT
A
L
L
L
R
R
R
D
OPTICAL
OUT
C
COAXIAL
OUT
Turntable
(MM cartridge)
Turntable
A
AUDIO OUT
L
R
GND
Connecting a CD recorder or MD recorder
If you wish to perform analog dubbing from a digital source, such as a CD or MD recorder to an
analog recorder such as a cassette deck, you will need to connect the analog inputs and outputs
as shown below, in addition to the digital audio connections.
NOTE:
• Do not connect the output of the component connected to the OPTICAL 4 OUT terminal on
the AVR-3806's rear panel to any terminal other than the OPTICAL 4 IN terminal.
Connecting a tape deck
19
Connecting Other Sources
CD recorder /
MD recorder
AUDIO OUT
A
L
L
L
R
R
R
AUDIO IN
A
L
L
L
R
R
R
D
OPTICAL
OUT
D
OPTICAL
IN
Tape deck
AUDIO OUT
A
L
L
L
R
R
R
AUDIO IN
A
L
L
L
R
R
R