Tone Defeat Mode; Channel Level; Fader Function - Denon AVR-3806S Operating Instructions Manual

Basic Operation
4
CURSOR G G
Press the button to select the "Tone
Defeat OFF".
5
CURSOR D D H H
Press the or
"Bass" or "Treble".
6 CURSOR F F G G
Press the or button to set the level.
To increase the bass or treble:
The bass or treble sound can be increased up to +6 dB in
steps of 1 dB.
To decrease the bass or treble:
The bass or treble sound can be decreased down to –6 dB
in steps of 1 dB.
7
ENTER
Press the button.
• The surround parameter menu screen reappears.
8
ENTER SURROUND PARAMETER
Press the or
button to complete the setting.

2 Tone defeat mode

If you do not want the bass and treble to be adjusted, turn on the
tone defeat mode.
TONE DEFEAT
Press the button to turn on the "Tone
Defeat" mode.
The signals do not pass through the bass and treble
adjustment circuits, providing higher quality sound.

Channel level

You can adjust the channel level either according to the playback
sources or to suit your tastes, as described below.
1
Press the
• The "Channel Vol." screen is displayed.
button to select the
Channels which is not used are not displayed.
2
Press the
select the speaker.
The channel switches as shown below each time the ENTER
button is pressed.
3
Press the
level.
The adjustment range for the different channels is +12 dB
to –12 dB in step of 0.5 dB.
The sound from the subwoofer can be completely cut by
lowering the SW (subwoofer) setting one additional from
–12 dB (setting it to "OFF").
• When the surround back speaker setting is set to "1spkr" for
"Speaker Configuration" (
ENTER
button.
CURSOR D D H H
ENTER
, or button to
FL C FR SW SR
FADER SL SBL SBR
CURSOR F F G G
or button to adjust the
page 75), this is set to "SB".
42

Fader function

This function makes it possible to lower the volume of the front
channels (FL, C and FR) or the rear channels (SL, SR, SBL and
SBR) together. Use it for example to adjust the balance of the
sound from each position when multi-channel music sources are
played.
1
ENTER
Press the button.
• The "Channel Vol." screen is displayed.
2
CURSOR D D H H
ENTER
Press the , or
select "Fader".
The channel switches in the order shown below each time
the ENTER button is pressed.
FL C FR SW
FADER SL SBL
CURSOR F F
3
Press the button to reduce the
volume of the front channels, the
button to reduce the volume of the rear channels.
Example: When "FRONT" is selected
The fader function does not affect the subwoofer channel
• The channel whose channel level is adjusted lowest can be
faded to –12 dB using the fader function.
• If the channel levels are adjusted separately after adjusting the
fader, the fader adjustment values are cleared, so adjust the
fader again.
Basic Operation
button, then
SR
SBR
CURSOR G G