Table of Contents
Advertisement
Easy Setup and Operation
POWER
ENTER
SYSTEM SETUP
ON/STANDBY
CURSOR
AMP
SYSTEM
SETUP
CURSOR
Connecting a microphone
SETUP MIC
1
Connect the microphone for Auto Setup to the
SETUP MIC
2
Mount the auto setup microphone onto a camera
tripod, etc., and place it at ear height at the main
listening position in the listening room with the
sound receptor facing the ceiling.
ON
OFF
ENTER
When placing the microphone, adjust the height so that the
microphone's sound receptor is at the height of the ears of
the listener.
Be sure that at the beginning, the measurement is started
with the microphone set up at the main listening position.
It is not possible to measure properly if there are any
obstacles between the speakers and microphone. Check
that there are no obstacles.
Please do not stand between or near the speakers and the
microphone during the measurements.
NOTE:
• Do not disconnect the microphone until the settings are
completed.
• Do not change the connection of speakers or the
subwoofer's volume after performing these measurements.
jack on the front panel of the unit.
Microphone
10
Easy Setup and Operation
Turning on the power
1
Turn on your subwoofer.
Set the volume to halfway and set the crossover frequency
to the maximum or Low pass filter off if your subwoofer can
adjust the output volume and the crossover frequency
Some subwoofers have a standby mode. Be sure to turn
this function off before performing the Auto Setup
procedure.
2
Turn on your monitor (TV).
3
POWER
Press the
switch.
ON:
¢
The power turns on and the indicator lights.
Set the POWER switch to this position to turn the power on
and off from the included remote control unit.
OFF:
£
The power turns off and the indicator is off.
In this position, the power cannot be turned on and off from
the remote control unit.
4
ON/STANDBY
Press the
switch on the main unit
ON
or
button on the remote control unit.
• When pressed, the power turns on and the display lights.
• When pressed again, the power turns off, the standby
mode is set and the display turns off.
The sound is muted for several seconds, after which the
unit operates normally.
When ever the ON/STANDBY button is in the standby state,
the apparatus is still connected to the AC line voltage.
Please be sure to turn off the POWER switch or unplug the
cord when you leave home for, say, a vacation.
5
AMP
Press the
button to select the "AMP" mode
(only when operating with the remote control
unit
).
(
page 26)
Hide quick links:
Advertisement
Table of Contents
