Width - Omron ZFX-C User Manual

Width

This item uses the changes in brightness in a region to detect edge(s). Two edges are found in a single
measurement region, and the distance between these edges is output as a dimension.
Setup
Start
point
Region settings
This function sets the measurement region.
MENU mode - [Setup] - [Item] - [Region]
Item
Measurement region
Reference registration
Threshold
This function sets the judgment conditions.
MENU mode - [Setup] - [Item] - [Limits]
Setup Item

Width

Position X1, Y1
Position X2, Y2
76
Setting Measurement Items
Measurement region
End
point
Edge 1
(start point side)
Description
This function sets the region to be measured.
Setting the Region p.213
When the measurement region is set, measurement is executed on the display image, and the result
of execution is registered as the reference value. To re-register only reference values, you can use
this function to re-register only reference values based on the image currently on screen.
Description
Sets the range of the edge width to be judged as OK.
Range: 0 to 9999.999
(When calibration is OFF, the range becomes 0 to 800.)
Sets the range of movement in the X- and Y- axes to be judged as OK.
Range: -9999.999 to 9999.999
(When calibration is OFF, the range of movement for positions X and Y are 0 to 640 and 0
to 480, respectively.)
Measurement
Two edges are searched in the region.
Edge 1 is searched from the start point towards the end
point. Edge 2 is searched from the end point towards the
start point.
Dimension
Edge 2
(end point side)
ZFX-C User's Manual