Omron ZFX-C User Manual page 72

Setup Item Setting value
Measure perimeter OFF (default value)
ON
Measure roundness OFF (default value)
ON
Filling up holes OFF (default value)
ON
Outside trimming OFF (default value)
ON
Area judgment 0 to 9999999.999
(default value: lower limit 0,
upper limit 307200)
Calibration OFF (default value)
ON
Coordinates mode Normal (default value)
Pos. correction
Coordinates mode p.75
Note
Area judgment screen
Crosshair cursors are displayed at locations in the labeling image area recognized as valid labels. Adjust the area
judgment value while checking whether or not the part to be measured is recognized correctly.
Camera image
ZFX-C User's Manual
Description
When "ON", the following parameters are calculated:
• Length X
• Length Y
• Perimeter
Sets whether or not to calculate roundness.
Roundness = (4π x area)/(perimeter x perimeter)
Selects how to process parts other than the target color that are
enclosed by the target color to be measured, such as a dough-
nut. When "ON" is set, parts are processed as the target color
to be measured.
Input image
Set this function when the measurement region contains colors
other than the measurement color that are not required in mea-
surement. When "ON" is set, the entire region outside of the
measurement region is measured as the color to be measured.
Input image
To calculate the
position and area
of this label
Sets the minimum and maximum area values to be counted as
a label. Adjust the setting value when noise is counted as a
label by mistake.
Measurement results are output using the camera's coordinate values.
Measurement results are output using the coordinate value
converted by the calibration function.
The position information of the input image coordinate system itself is output.
When position shift correction is set, the position information is
output using the coordinate system corrected to the original
state when the coordinate system was registered.
2.Labeling Area judgment SD
0 LIVE
Camera
L H
L: 0 H: 307200
Apply Cancel Capture
Length Y
Length X
Filling up holes: ON
Outside trimming: ON
Measurement region
The region outside of the
measurement region is taken to be the
color to be measured.
Sort mode: Area descending order
When "Label No." is set to "1", the label
position and area in the center are calculated.
Labeling image
Setting Measurement Items
Measurement
target
69