Omron ZFX-C User Manual page 65

• Verification and Candidate level p.49
• Search Rotation Range p.49
• Setting the Candidate level p.49
• Coordinates mode p.75
Note
The minimum size of subdivided models is 32 x 32 pixels.
Important
When the sensitivity, rotation range, and skipping angle have been changed, register the model again.
Possible output results
The following values can be output when expressions are set.
Item
Judgment result
Correlation
Measurement position
Solid color rate
Measurement angle
62
Setting Measurement Items
Description
The judgment result is output. (0:OK, -1:NG, -2: not measured)
The degree of match between the measurement image and model
image are output as a correlation value. The correlation and position
information of the model having the lowest degree of match of the
subdivided models is output. (0 to 100)
When [Difference position] is selected at [Output position]:
The X, Y coordinates of the location having the lowest correlation
value, as a result of having calculated the correlation value in detail by
subdivided models, are output. (-9999.999 to 9999.999)
When [Center position] is selected at [Output position]:
The center coordinates of the model that was found are output.
(-9999.999 to 9999.999)
The rate that the model is a solid color is output. The higher the solid
color rate, the higher the value increases. (0 to 100)
The rotation angle of the model that was found is output. (-180 to 180) Angle (TH)
Message
Judge (JG)
Correlation (CR)
Position X, Y
(X, Y)
Solid color rate
(SC)
ZFX-C User's Manual