Editing Acceleration/Deceleration Time Settings; Acceleration/Deceleration Time Setting Screen - Omron WS02-NCTC1-E - 07-2001 Operation Manual

Editing Acceleration/Deceleration Time Settings

4-6

Editing Acceleration/Deceleration Time Settings

4-6-1

Acceleration/Deceleration Time Setting Screen

4-6-2 Editing Acceleration/Deceleration Time Settings
To Clear to Default
Settings
To Copy Axes
On the project tree, either double-click Edit Accel/Decel, or select it and press
the Enter Key.
Example: The following will be displayed as the 4-axis NC Unit Acceleration/
Deceleration Time Setting Editing Screen.
The acceleration/deceleration time setting range is from 00000000 to
0003D090 Hex (0 to 250,000) (ms). After the settings have been entered and
the Enter Key pressed, the cursor will move to the next setting.
Example: The following will be displayed as the Acceleration/Deceleration
Time Setting Editing Screen.
Use the following procedure to clear specific settings to their default values.
(Refer to 4-2-4 Clearing Settings for details.)
1,2,3... 1. On the acceleration/deceleration Setting Editing Screen, select the set-
tings to be cleared to their default values, or designate the range by clicking
and dragging.
2. Select Edit/Clear
For 2-axis and 4-axis NC Units, data can be copied from one axis to another
axis by selecting the source and destination axes. (Refer to 4-2-5 Copying
Axis Settings for details.)
1,2,3... 1. Select Edit/Copy Axis.
2. Under From and To, select the axes to be copied from and to respectively.
3. Click the OK Button.
Section 4-6
59