Basic Operating Procedure - Omron WS02-NCTC1-E - 07-2001 Operation Manual

Basic Operating Procedure

Item
Method for connect- • Connected to the RS-232C port on the CPU Unit or a
ing to PC
• Connected to the peripheral port on the CPU Unit
Networks for con- Select from the following using the FinsGateway driver:
nection to PC
• Host Link (SYSWAY-CV or RS-232C)
• Ethernet (via an Ethernet board)
Decimal/binary dis- Supported.
play selection
Changing display Supported.
font size
NC Unit error log dis- Supported.
play
1-5

Basic Operating Procedure

CX-Position
Serial Communications Board/Unit using an RS-232C
cable.
using a peripheral cable, or via Ethernet.
A basic outline of the procedures required to install the CX-Position and Fins-
Gateway, create data, transfer it to the NC Units, and use in actual operation
is given below.
SYSMAC-NCT
Connected to the RS-232C port on the
CPU Unit using an RS-232C cable.
Host Link (RS-232C) only
Not supported (decimal only).
Not supported.
Not supported.
Section 1-5
7