Transferring And Verifying Data; Section 7 - Omron WS02-NCTC1-E - 07-2001 Operation Manual

This section provides information on data transfer and verification operations between the CX-Position and NC Units, and
about operations for writing data transferred to NC Units into the NC Unit flash memory.
Connect the computer to the PC with a Connecting Cable and confirm that you are online before attempting to transfer or
verify data or write data to the flash memory. (Refer to 2-2 Connecting to a PC and 6-2 FinsGateway Configuration and
Startup.)
If OMRON Support Software that communicates using CX-Server (e.g., CX-Programmer, CX-Protocol, or CX-Motion)
or an application that uses a special serial driver is connected online, it is not possible to perform online operations from
CX-Position using the same COM port. The reverse is also true.
Quit online connection for the OMRON Support Software that communicates using CX-Server (e.g., CX-Programmer,
CX-Protocol, or CX-Motion) or the application that uses a special serial driver, and then re-attempt online operations from
CX-Position after starting up FinsGateway's Serial Unit servicing.
7-1 Downloading Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-2 Uploading Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-2-1 Uploading Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-2-2 Automatic NC Searches . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-3 Verifying Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-4 Writing Data to Flash Memory . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Transferring and Verifying Data

SECTION 7

74
75
75
76
77
78
73