Devicenet Wireless Slave Station Entry - Omron WD30-ME Operation Manual

System Initial Setting and Starting Communications
2-4-3

DeviceNet wireless slave station entry

Enter the wireless slave station in the wireless master station.
If the same system configuration as for the network default settings (Refer to
1-2 Basic Functions of the DeviceNet Wireless Unit.) is used, there is no need
to do this registration. In addition, when not using the WNODE = 1 wireless
slave station (entry is complete with default settings when sent from the fac-
tory), it must be deleted before proceeding with entry.
The specifics of this example are explained below.
First, begin with the WNODE = 1 wireless slave station.
Master station
W NODE
X10 X1
SW2 W CH
RUN
TEST
X10 X1
SET
SW3
ON
1 2 3 4 5 6 7 8
Master station
W NODE
X10 X1
SW2 W CH
RUN
TEST
X10 X1
SET
SW3
ON
1 2 3 4 5 6 7 8
Master station
W NODE
X10 X1
SW2 W CH
RUN
TEST
X10 X1
SET
SW3
ON
1 2 3 4 5 6 7 8
Master station
MS NS WS
N NODE
SW2
RUN
TEST
X10 X1
SET
SW1
ON
1 2 3 4
1. Use the wireless master station WN-
ODE = 1.
2. To enter the wireless slave station,
set SW3 to "bit 6 = ON".
3. Set the wireless master station
mode select switch to "SET".
4. Turn ON the wireless master station
communications
Once the MS LED flashes green
and SW2 is pressed, the addition of
the wireless slave station begins.
Section 2-4
power supply.
29