System Initial Setting and Starting Communications
2-4
System Initial Setting and Starting Communications
2-4-1
System start
1,2,3...
26
Example 2:
Connecting the cable to the top, and installing a terminating resistor
Example 3:
Connecting the cable to the bottom, and installing a terminating resistor
The required entries, and deletion and initialization procedures following sys-
tem start are explained in this section.
Turn on the communications power source and the node power supply in the
following order.
1. DeviceNet slave (environment-resistant terminal) external power supply
2. DeviceNet master (C200HW-DRM21-V1) power supply
It is also OK to turn all power supplies on simultaneously.
Special cable
Plug
Socket
Model
Plug
Socket
DCN2-1
Socket
Plug
Model DRS2-1
Shielded terminating resistor
Plug
Socket
Model DCN2-1
Plug
Plug
Socket
Socket
Dedicated cable
Section 2-4
Model DRS2-2