Reading Actual Time Of Wireless Communication Cycle - Omron WD30-ME Operation Manual

List of Explicit Messages Addressed to DeviceNet Wireless Master Station
Explicit message Function
Setting upper sta- Sets the node address of the
tion node address upper station on the relay
route of a specified wireless
slave station.
Reading upper Reads the node address of
station node the upper station on the relay
address route of a specified wireless
slave station.
Reading wireless Reads the status information
network status of wireless network between
the master station and a
specified wireless slave sta-
tion.
Reading wireless Reads the error counts
error count between the master station
and a specified wireless
slave station.
Reading Reads the DeviceNet master
DeviceNet mas- status of a specified wireless
ter status slave station.
Writing settings/ Writes settings in EEPROM
soft reset or executes soft reset.
7-2-1

Reading actual time of wireless communication cycle

Command format
Response format
ServiceCode For-
mat in ( ) is
response
10 Hex (90 Hex) A8 Hex
0E Hex (8E Hex) A8 Hex
0E Hex (8E Hex) AA Hex
0E Hex (8E Hex) AA Hex
0E Hex (8E Hex) AA Hex
10 Hex (90 Hex) AC Hex
The following pages explain each command. By the way, in the command
(response) format, the command codes and end codes in the header section
are omitted.
Reads the latest actual time of wireless communication cycle at a user sys-
tem.
00 0E 00 A6
ClassID
ServiceCode
Destination node address
00
04 00
No. of received bytes
Source node address
ClassID InstanceID AttributeID Page
01 to 40
Hex
01 to 40
Hex
01 to 40
Hex
01 to 40
Hex
01 to 40
Hex
01 Hex
00 01 64
InstanceID
AttributeID
8E
Data
ServiceCode
Section 7-2
6F 95
6E 96
64 96
65 97
67 98
64 99
89