Actual Example
6-2
Actual Example
6-2-1
System configuration example
6-2-2
System setting
Preparation
Setting from the
configurator
6-2-3
Installation test
Temporary installation
Wireless slave station
WNODE=02 SW1=bit3 OFF
(not dedicated for relay station)
Although omitted in the above illustration, it is assumed that the communica-
tion power is supplied to all wireless units via the communication cables and
that terminators are installed.
Connect the wireless master station and configurator with the DeviceNet net-
work. The wireless slave stations do not need to be prepared at this stage.
After starting up the configurator, set the system configuration of the relay sta-
tion and enter it in the wireless master station on the screen of the parameter
setting function of the wireless unit.
• Temporarily install the wireless master station, relay station, and slave
stations to the respective determined positions.
• Set the switches as described in the illustration of the system configura-
tion example.
DeviceNet master
Configurator
unit
DeviceNet network
Wireless master station
WNODE=00
Wireless slave station
WNODE=01 SW1=bit3 ON
(dedicated for relay station)
DeviceNet slaves
Section 6-2
1 relay stages
(no. of hops:2)
81