Configurator Outline; Configuration; Operating Environment - Omron WD30-ME Operation Manual

Configurator Outline

1-3

Configurator Outline

1-3-1

Configuration

1-3-2

Operating environment

Product Model
Configurator WS02-CFDC1-E Installation disk
(Ver. 2.@)
Model
3G8F5-DRM21 Dedicated ISA Board and Configurator
(Ver. 2.@) installation disk
3G8E2-DRM21 Dedicated PCMCIA Card and Configurator
(Ver. 2.@) installation disk
12
Also, if serial number check is enabled for all the wireless slave stations regis-
tered to a wireless master station, and all of the wireless slave stations' serial
numbers are registered to the wireless master station, the dot on the left-hand
side of the wireless master station's 7-segment LED lights.
This is the Windows application that runs the DeviceNet computer master sta-
tion.
Master and slave unit settings can be referenced (slave entry, I/O allocations,
wireless network protocol parameters, commands issued), conditions moni-
tored, used frequency bands (channels) monitored, and running tests per-
formed from the DeviceNet configurator (Ver. 2.0 or later).
The computer running the Configurator is connected to the DeviceNet net-
work by installing an OMRON DeviceNet Board in the computer or by con-
necting the computer to a serial communications port (peripheral port) of the
CS1W-DRM21 DeviceNet Unit on a CS1-series PLC.
Note In both cases, the same online functions are supported.
This is the operating environment for the DeviceNet configurator.
Contents
Either one of the following
(CD-ROM) methods
• Serial connection
• Dedicated PCMCIA Card
• Dedicated ISA Board
Note Use the following dedicated Boards and Card
Contents
Method of connecting
personal computer to
network
(see table below)
Personal
computer
IBM PC/AT or
compatible
Section 1-3
Personal
computer
IBM PC/AT or Windows 95, 98,
compatible 2000 or NT4.0
OS
Windows 95, 98 or NT4.0
Windows 95 or 98
OS