Displays - Omron WD30-ME Operation Manual

DeviceNet Wireless Master Station Specifications
WNODE switch
Mode select switch
Push button "SW2"
4-1-3

Displays

Status LED
LED Color
MS Green
(Module
Status)
Red
-
NS Green
(Network
Status)
Red
-
Tips for using
the mode
select switch
Set the wireless interface node address. During normal operation, the setting
for this switch is ignored by the wireless master station and a node address of
00 is used for operation.
W NODE
X10 X1
Set the wireless master station operation mode (3 positions).
RUN
TEST
SET
Operation mode
Normal mode
Test mode
Setting mode
Used as a trigger for making various settings while in Setting mode.
SW2
Status
On Normal conditions
Flashing Test/Setting mode
On Critical malfunction
Flashing Minor malfunction
Off No power supply
On Online/communication
connection complete
Flashing Online/communication
connection not com-
plete
On Critical communica-
tion error
Flashing Minor communication
error
Off Offline, power turned
off
The software is reset (switch settings are reread) when the mode select switch is changed. It
should be used when you want to enable the switch changes on the main unit.
SW status
RUN
TEST
SET
Meaning (primary error)
Communication is normal.
Test mode or Setting mode has been activated.
A critical error has occurred that can not be recov-
ered. The unit must be replaced.
An error has occurred that can be recovered by
resetting the system.
Power is not being supplied, or the system is reset-
ting.
Remote I/O communications are established while
online.
Or, message communications are established.
Although the system is online, remote I/O communi-
cations and message communications are not
established.
Communication is not possible.
Communication timeout
The system is not online.
Section 4-1
59