Table of Contents
Advertisement
2-4 Connecting Video Input Connectors
2-4 Connecting Video Input Connectors
This section describes the procedure for connecting cameras to the RGB and Video
Input Unit mounted on the PT.
The cable's tensile load is 30 N maximum. Do not subject it to loads greater
Note
than this.
Connecting Video Input Connectors
(1) Insert the BNC socket on the camera's output cable into a video input
connector.
(2) After inserting the BNC socket, twist it clockwise until it locks into place.
Twist clockwise
2-10
Insert the BNC socket so that the groove
is aligned with the protuberance.
Protuberance
BNC
socket
Video input connectors
Advertisement
Table of Contents
