Omron CPM1A Operation Manual page 47

Sysmac series programmable controllers
Hide thumbs Also See for CPM1A:
Table of Contents

Advertisement

Specifications
Item
CPM1A-10CDR-j(-V1)
CPM1A-10CDT-j(-V1)
CPM1A-10CDT1-j(-V1)
Pulse output
One point, 20 Hz to 2 kHz (single-phase output)
Can preset the pulse rate (1 to 16,777,215).
Input time constant
Can be set to 1 ms, 2 ms, 4 ms, 8 ms, 16 ms, 32 ms, 64 ms, or 128 ms.
Analog controls
2 controls, setting range: 0 to 200 BCD
Memory Backup
24
CPM1A-20CDR-j(-V1)
CPM1A-20CDT-j(-V1)
CPM1A-20CDT1-j(-V1)
Note
1. Use TIM 000 to TIM 003 when creating a timer using the high-speed timer
instruction to perform interrupt processing.
2. The input interrupt response time is 0.3 ms max.
The user program and memory area data in the CPM1A are backed up either by
an internal capacitor or in flash memory as shown in the following table.
Backup method
Internal capacitor
Flash memory
Note
1. The IR, TR, LR, and timer areas are not normally backed up when power is
turned off and all contents will be cleared the next time power is turned on.
(The PC Setup setting in DM 6601 can be used to back up this data. Refer to
details on the PC Setup later in this manual for details.)
2. The bits in the AR and SR areas have special functions and are set accord-
ing to these functions when power is turned on.
The capacitor backup time depends on the ambient temperature, as shown in
the following graph. The backup time, however, assumes that the capacitor is
fully charged, which requires that power be supplied to the CPU Unit continu-
ously for at least 15 minutes.
If the power remains off for a period exceeding the data backup period,
AR 1314 will turn ON to indicate that the capacitor can no longer back up data
and the data backed up by the capacitor will be cleared. AR 1314 will remain
ON unless it is turned OFF using I/O monitor operations, using memory clear
operations, or from the user program.
If desired, the PC Setup setting in DM 6604 can be set to create a fatal error
and thus stop the system when AR 1314 goes ON.
CPM1A-30CDR-j(-V1)
CPM1A-30CDT-j(-V1)
CPM1A-30CDT1-j(-V1)
Read/write DM area (DM 0000 to DM 0999, DM 1022, and
DM 1023)
Error log area (DM 1000 to DM 1021)
HR area (HR 00 to HR 19)
Counter area (CNT 000 to CNT 127)
User program
Read-only DM area (DM 6144 to DM 6599)
PC Setup (DM 6600 to DM 6655)
20
10
7
1
25
40
Ambient temperature (_C)
Section 2-1
CPM1A-40CDR-j(-V1)
CPM1A-40CDT-j(-V1)
CPM1A-40CDT1-j(-V1)
Data
80

Advertisement

Table of Contents
loading

Table of Contents