Omron CJ - 10-2005 Manual page 46

Using the Programming Console for the First Time
20
The Programming Console can be connected even when power is being
supplied to the PLC and regardless of whether the CPU Unit is in RUN,
MONITOR, or PROGRAM mode.
2. When the power is turned ON, the POWER indicator on the Power Supply
Unit will light and the LCD display on the Programming Console will display
the following.
• Enter the password.
CLR
• The Programming Console is equipped with a password so that the
PLC is operated only by experienced staff to ensure safe operation
and prevent accidents. It will be necessary to enter the password by
pressing the CLR Key and then the MON Key after the power is turned
ON or after the Programming Console is connected. Refer to 3-1 Start-
ing Operation for details.
• The key buzzer can be turned OFF by pressing the SHIFT Key and
then the 1 Key after entering the password.
3. Access the initial display.
• If a memory error is displayed, press the CLR Key several times to re-
turn to the initial display.
• If an I/O table verification error occurs, I/O VRFY ERR will be dis-
played. Either connect the correct Unit, or press the CLR Key to ignore
the error.
4. Clear all memory.
• The memory clear operation initializes (formats) the memory area.
Power ON
CS1 CPU Unit
<PROGRAM>
PASSWORD!
CJ1/CJ1-H/CS1-H CPU Unit
<PRG> 3:JPN~ENG
PASSWORD!
CS1 CPU Unit
<PROGRAM>
MON
CJ1/CJ1-H/CS1-H CPU Unit
<PRG>
3:JPN~ENG
000000 CT**
CLR
Section 2-3
BZ
BZ