Omron CJ - 10-2005 Manual page 177

PLC Setup Coding Sheets for Programming Console
Address
(CS1D Duplex-CPU Systems only)
96@@@@
Value (Hex)
0000
8000
40@@
C0@@
Note The above settings assume that both bit 11
(Inner Board parameter area) and bit 10
(Inner Board variable area) are set to 0.
Address
(CS1D CPU Units only)
121@@@@
Value (Hex)
0000
0001
to
8000
Note Up to three bits (unit numbers of duplex
units) may be turned ON at the same time.
Address
(CS1D CPU Units only)
122 @@@@
Value (Hex)
0000 Allow only one Unit to be replaced
online at a time.
8000 Allow simultaneous online replacement
of more than one Unit.
Address
(CS1D Duplex-CPU Systems only)
123@@@@
Value (Hex)
0000
4000
8000
C000
Duplex transfer settings
Program transfer EM Area transfer
Transfer program Transfer together
Do not transfer Transfer together
program
Transfer program Transfer over
multiple scans
Note: @@ is the
division size
(words).
Do not transfer Transfer over
program multiple scans
Note: @@ is the
division size
(words).
Active/Standby Duplex
Communications Unit settings
Not duplex for unit Bits 00 to 15
numbers 0 to 15. correspond to
unit numbers 0
Duplex for unit
to 15.
number 0 only.
Duplex for unit
number 15 only.
Multiple Unit online replacement
Operation during Automatic
duplex initialization recovery to
duplex operation
Do not run during Do not recover
initialization automatically
Run during Do not recover
initialization automatically
Do not run during Recover
initialization automatically
Run during Recover
initialization automatically
Appendix C
151