Omron CJ - 10-2005 Manual page 41

Programming Console Connection and Installation
Panel Mounting
CJ-series PLCs
Check the direction of the
connector.
3. To disconnect the connector, squeeze the lock release levers on the sides
and pull the connector straight out.
Lock release lever
Use the C200H-PRO27-E Programming Console when the Programming
Console needs to be mounted to a panel. Follow the instructions below for
mounting the Console to a panel. (The C200H-ATT01 Mounting Bracket is
sold separately.)
Mounting Bracket
Panel thickness: 1.0 to 3.2 mm
When mounting the Console to a panel, allow enough space for the cables.
37
Squeeze in on the sides of the
connector and then insert it.
Mounting hole dimensions
(DIN43700 standards)
Two screws
15
At least 80 mm is required.
Either connector may
be used.
About 70 mm is required.
Section 1-6
+1.1
186
-0
+0.8
92
-0
15